Frequently Asked Questions about Artesyn's PM/PPC boards
Here are some frequently asked questions (and answers) about Artesyn's PM/PPC boards.
This FAQ is very much a work in progress. If you have additional
information, questions, or answers, send mail to
NetBSD is booted over the network. You need two things: a TFTP server to load the kernel image and an NFS server for the file systems.
The NetBSD kernel has been relocated for loading at address 0x40000, so the Artesyn monitor has to be set up for this load address. Use the monitor commands nvdisplay and nvupdate to configure the boot parameters, and boottftp to boot.
NetBSD can configure the PCI devices if the option PCI_NETBSD_CONFIGURE is used. This may not work if the firmware also configures the devices. The firmware configuration can be turned off using nvdisplay.
Yes, the same kernel that is booted over TFTP can be flashed. The steps are:
Get the kernel into memory:
tftp_get kernel-name 40000
Write it to flash. The size of the kernel is reported by tftp_get. Use it in the command to copy from RAM to flash:
flashblkwr 40000 70000000 size
Use nvdisplay to make sure that
CopyToLoadAdris set, that
RomBase=70000000, and that
RomSizeis large enough to copy the whole kernel.
Other sources of information
Back to NetBSD/evbppc port page